Cracks
Cracked Fiberglass
Brittle panels crack from hail, foot traffic or age, letting rain straight through the roof onto whatever sits below.
Rockcastle County · State Permits
Mount Vernon Metal Roof Coating
We do metal roof coating in Mount Vernon and around Rockcastle County, including the call on every old skylight panel: keep it for daylight or close it in with steel.
Local Focus
Skylight Panels On Mount Vernon Buildings
Old fiberglass skylight panels turn brittle and yellow, and many were never sealed at their laps. Each one gets a decision early: replace it with new fiberglass for daylight, or cover it with a metal panel.
That choice goes into the job description for the state. A Mount Vernon building answers to the Kentucky HBC, since the Rockcastle County listing shows no local building inspector.
- Brittle panels replaced or covered with steel
- Perimeter laps wrapped in fabric either way
- Skylight count marked on the roof plan for the state
Roof Conditions
Skylight Problems We See Around Mount Vernon
Skylight panels fail in a few predictable ways, and each one changes the plan.
Laps
Open Perimeter Laps
The laps where a skylight panel meets the steel on each side were often left unsealed, and water runs in along them.
Fasteners
Fasteners Through Fiberglass
Screws through brittle fiberglass loosen and crack the panel around them, opening a ring of leaks at each fastener.
Curbs
Skylight Curbs Holding Water
Raised skylight curbs on low slopes dam the water running down the panels, so the uphill side of each curb stays wet after rain.
Benefits
Benefits of Coating Your Roof
Handling the skylights during the coating job pays off in a few ways.
One Job For Field And Skylights
Skylight swaps and the coating happen together, so the crew details each new panel edge while the fabric and base coat are already on the roof.
Daylight Kept Where You Want It
Owners who rely on skylight light keep it with new fiberglass, and areas that never needed it get solid steel panels that match the roof and take the same coating.
Lower Cost Than Re-Roofing
Solid panels and framing stay in place, so the skylight work is the main repair cost instead of a full re-panel, and the framing under the roof goes untouched.
Fewer Leak Points Later
Covered or replaced skylights with fabric-wrapped laps remove the weakest spots on an older metal roof, the panels most likely to crack in the next hailstorm.
Coating Options
Commercial Roof Coating Options for Mount Vernon
Mount Vernon metal roofs take one of these systems once the skylights are sorted.
Silicone On Low Slopes
Low-slope roofs with water sitting around skylight curbs get silicone, which holds up where water lingers. Granules go in the walk lanes.
Silicone Roof Coating
Acrylic On Steeper Roofs
Pitched roofs that drain fast take a white acrylic finish over the new skylight edges. Recoats later have more product choices.
Acrylic Roof Coating
Foam Where Skylights Close
Buildings closing in most skylights and wanting insulation can take foam over the whole roof before the coating. New edge trim covers the added height.
Spray Foam RoofingRain Coming Through A Skylight?
Tell us how many skylight panels the roof has and which ones leak. That sets the first visit's priorities.
Process
How A Mount Vernon Coating Job Is Planned
Five decisions, with the skylight call made early.
- On The Roof
Inspect Your Roof
We walk every panel and skylight, check laps and fasteners around each one, and look up from inside to see which panels let light and water through.
- Decision
Keep Or Close Each Skylight?
Owners mark which skylights to keep for daylight. Those get new fiberglass, and the rest get covered with metal panels matched to the roof profile.
- Permits
What Goes To The State?
Describe which panels stay, which come off, and what happens at ridge caps and skylights. A roof plan marking curbs and gutter runs helps the state office follow the job.
- Utilities
Who Feeds The Meter?
Service drops often attach near the eave, along the roof edge where lifts and hoses go. Inter-County Energy, Jackson Energy and South Kentucky RECC serve Rockcastle County.
- Coating
How Is It Coated?
Every skylight perimeter gets fabric in base coat, then the field coat goes on across the roof to the specified thickness.
Nearby Towns
Other Towns In Our Service Area
Our metal roof coating area reaches the towns below. For a building beyond them, call us or send us a message.
Berea
City permits, state plan review, equipment-heavy roofs.
Irvine
Estill County barns where condensation rusts panels from below.
Stanton
Powell County shops where gutters and downspouts matter most.
McKee
Jackson County roofs with purlins checked before coating.
Waco
Unincorporated farm sheds with lean-to roofs, some now shops.
Paint Lick
Garrard County roofs needing ridge cap and eave trim work.
Ravenna
River and rail town where roof panels get washed first.
Kingston
Outside Berea's line, with service masts through roof panels.
FAQ
Mount Vernon Metal Roof Coating Questions
What Mount Vernon owners ask about permits, utilities and skylights.
Question about your own roof?
Call UsDoes a Mount Vernon metal building need a state roofing permit?
Permits go through the Kentucky HBC, since the state's Rockcastle County listing shows no local building inspector.
For a coating job, describe which panels stay, which come off, and what happens at ridge caps and skylight panels. Framing changes or added foam thickness at the roof edge belong in that description too.
Which electric cooperatives serve Mount Vernon buildings?
Three cooperatives serve Rockcastle County, according to East Kentucky Power Cooperative: Inter-County Energy, Jackson Energy and South Kentucky RECC. Check which one feeds your meter ahead of the roof work.
Service drops often attach near the eave where lifts and hoses go, and the cooperative is the call for any line touching the roof edge.
Should old skylights be replaced or covered?
That turns on whether the space below needs daylight. Replacement fiberglass keeps the light, while a metal panel removes a weak spot for good and matches the coating over it. Either way, the perimeter laps get fabric.
Can a cracked skylight be coated over?
Coating over brittle fiberglass seldom lasts, because the panel keeps cracking under it. Cracked panels are replaced or covered first, and the coating ties into the new edges.
What should I check after a Jackson wind warning?
Mount Vernon warnings come from the NWS office in Jackson. Check eave trim and gutters near the service drop first, then ridge caps and skylight edges, since wind gets under loose trim before anything else.
Do new skylight panels need to match the roof profile?
Yes. Replacement fiberglass or metal panels are ordered in the same rib profile as the roof, so the laps nest tightly before fabric and coating go over them. A mismatched profile leaves gaps that coating fills poorly.
Sort Your Skylights And Coat The Roof
Start a free estimate for your Mount Vernon building, or call to talk through the skylight panels.